Fluke 434-II User Manual page 84

Fluke 434-II/435-II/437-II
Users Manual
Normal lists the major event characteristics: start date/time, duration, event type, and
magnitude.
Detail gives information on threshold crossings for each phase of an event.
Wave event shows a scope waveform around the selected event. RMS event shows the ½
cycle rms trend around the selected event. Wave event and rms event are available in
Fluke 435-II and 437-II.
The following Abbreviations and Symbols are used in the tables:
Abbreviation
CHG
DIP
INT
SWL
Hx
TRA
AMP
Available function keys:
Two ways to access Trend:
1. Use the up/down arrow keys to highlight an event in the table. To access Trend press
2. Press Function key F4 to view the Trend part showing the most recent measuring
16-6
info@Fluke-Direct.ca
Meaning
Rapid Voltage Change
Voltage Dip
Voltage Interruption
Voltage Swell
Number of the harmonic
that violated its limits
Transient
Amp value exceeded
Switch to wave event display: this will show a 4 cycle
F1
waveform around the selected event. Available in HOLD.
Switch to rms event display: this will show the ½ cycle rms
F2
trend around the selected event. Available in HOLD.
Switch between Normal and Detailed events table.
F3
Return to previous menu.
F4
the ENTER key. The Cursor is on, in the mid of screen and located on the selected
event. Zoom is set to 4.
values. Cursor and Zoom can be switched on afterwards when required.
Fluke-Direct
Symbol Meaning
High value of 100 %
limit has been violated
Low value of 100 % limit
has been violated
High value of x % limit
has been violated
Low value of x % limit
has been violated
Unbalance event
Change upwards
Change downwards
.ca
1.800.868.7495