5. 2. 9
<Fr: Panel Fwd/Rev run select>
Basic parameter
■ Function
This parameter is used to select the direction of rotation of the motor during panel run.
The direction of rotation can be changed during run by using the [FWD/REV] key on the operation
4
panel.
5
■ Parameter setting
Title
Fr
■ Selecting a setting value
9
0: Fwd run
When you press the [RUN] key on the operation panel, the motor runs forward.
Forward run/reverse run cannot be switched.
1: Rev run
When you press the [RUN] key on the operation panel, the motor runs reversely.
Forward run/reverse run cannot be switched.
2: Fwd run (switchable F/R by panel)
When you press the [RUN] key on the operation panel, the motor runs forward.
When you press the [FWD/REV] key during forward run, the motor starts running reversely. When
you press the [FWD/REV] key again, the motor starts running forward.
The command given before "MOFF" display is remained at the power off.
3: Rev run (switchable F/R by panel)
When you press the [RUN] key on the operation panel, the motor runs reversely.
When you press the [FWD/REV] key during reverse run, the motor starts running forward. When you
press the [FWD/REV] key again, the motor starts running reversely.
The command given before "MOFF" display is remained at the power off.
■ Direction of rotation of motor
You can check the direction of rotation of the motor with the following display.
5. [Fundamental operation] How to use parameters
Switching direction of rotation during panel run
Parameter name
Panel Fwd/Rev run
select
Fr : Panel Fwd/Rev run
0: Fwd run
1: Rev run
2: Fwd run(switch F/R by panel)
3: Rev run(switch F/R by panel)
Adjustment range
0: Fwd run
1: Rev run
2: Fwd run (switchable F/R by panel)
3: Rev run (switchable F/R by panel)
5-60
E6582062
STOP
0.0Hz
15:28
Default
setting
0