Toshiba TOSVERT VF-AS3 Instruction Manual page 139

• How to switch the display mode of the operation panel -> Refer to [3. 1. 2]
• Procedure to change parameter setting -> Refer to [4. 2. 3]
• Details of <CMOd: Run command select>, and <FMOd: Frequency command select 1> ->
Reference
Refer to [5. 1. 1]
• Difference of connection between sink logic and source logic -> Refer to [2. 3. 5]
• Details of operation by external signals -> Refer to [Chapter 7]
MCCB
1 Turn off the power of the inverter.
Remove the covers of the control terminal block and parts required for connection.
2
to be removed vary depending on the type of the inverter.
For details of how to remove the covers, refer to [2. 2].
PA/+ PB PC/-
R/L1
S/L2
T/L3
Operation panel
CC RR RX
4-31
Motor
U/T1
M
V/T2
W/T3
F
Fwd run
Common
CC
PP
Voltage signal: -10 to +10 Vdc
External potentiometer
4. [Basic operation] Operation methods of motor
E6582062
3
4
9
Covers