the cable sockets on the system board. The cable sockets on the system board are fragile. Any
damage to the cable sockets may require replacing the system board.
Step 7.
Pull the two plungers while you push the backplane to the left to disengage the backplane.
• For eight 3.5-inch hot-swap hard disk drive backplane
Plunger
Figure 134. 3.5-inch hot-swap hard disk drive backplane removal
• For twelve 3.5-inch hot-swap hard disk drive backplane
Plunger
Figure 135. 3.5-inch hot-swap hard disk drive backplane removal
Step 8.
Rotate the backplane toward the rear of the server and lift the backplane up to remove it from
the server.
2
1
2
1
Chapter 5
4
3
4
3
.
Removing, and replacing components
187