Lenovo HX3510-G Installation And Service Manual page 158

Step 4. Reinstall any adapters and reconnect any internal cables you might have removed in other
procedures (see "Replacing an adapter" on page 152 and "Internal cable routing and connectors"
on page 111).
Step 5. Align the riser-card assembly with the selected PCI connector on the system board and align it with
the slots on the chassis; then, lower it into the server and press down firmly until the riser-card
assembly is seated correctly in the connector on the system board.
• For half-length and low profile adapters (for HX7510 only)
Figure 75. Riser-card assembly installation - half-length and low profile adapters
• For full-height, full-length adapters (for HX3510-G only)
Note: Shipping brackets are only included in the server that is pre-configured with full-height,
full-length adapters
146
HX3510-G, HX5510, HX5510-C, HX7510 Installation and Service Guide
PCI riser-card assembly2
PCI riser-card assembly1