Lenovo HX3510-G Installation And Service Manual page 175

3. Remove the top cover (see "Removing the top cover" on page 116).
4. Remove the fan cage assembly (see "Removing the fan cage assembly" on page 135).
5. Disconnect the front USB/operator information panel cables from the connector mounted on the
chassis side wall.
Note: Disengage all latches, release tabs or locks on cable connectors when you disconnect all cables
from the system board. Failing to release them before removing the cables will damage the cable
sockets on the system board. The cable sockets on the system board are fragile. Any damage to the
cable sockets may require replacing the system board.
Figure 98. Front USB/operator information panel cable removal
6. Loosen screws and remove them.
Screws
Figure 99. Screw removal
7. To remove the cable cover, angle the cable cover as shown in the following illustration and slide the
cable cover slightly towards the rear side of the server to remove it from the server.
Front USB / operator
information panel cable
.
Chapter 5 Removing, and replacing components
163