Grandstream Networks GXP2130 Administration Manual page 70

Preferred DNS Server
Ipv6 Address Type
Static Ipv6 Address
Ipv6 Prefix Length
Ipv6 Prefix
DNS Server 1
DNS Server 2
Preferred DNS server
Network  Advanced Settings
802.1X mode
802.1X Identity
MD5 Password
802.1X CA Certificate
802.1X Client
Certificate
HTTP Proxy
HTTPS Proxy
Bypass Proxy For
Layer 3 QoS for SIP
Layer 3 QoS for RTP
Enable DHCP VLAN
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS 802.1p
Priority Value
Enters the Preferred DNS Server for Ipv4.
Allows users to configure the appropriate network settings on the phone to
obtain Ipv6 address. Users could select "Auto-configured" or "Statically
configured" for the Ipv6 address type.
Enter the static Ipv6 address when Full Static is used in "Statically
configured" Ipv6 address type.
Enter the Ipv6 prefix length when Full Static is used in "Statically configured"
Ipv6 address type.
Enter the Ipv6 Prefix (64 bits) when Prefix Static is used in "Statically
configured" Ipv6 address type.
Enter the DNS Server 1 for Ipv6.
Enter the DNS Server 2 for Ipv6.
Enter the Preferred DNS Server for Ipv6.
Allows the user to enable/disable 802.1X mode on the phone. The default
value is disabled. To enable 802.1X mode, this field should be set to EAP-
MD5, users may also choose EAP-TLS, or EAP-PEAP.
Enter the Identity information for the 802.1x mode.
Enter the MD5 Password for the 802.1X mode.
Upload 802.1X CA certificate to the phone; or delete existed 802.1X CA
certificate from the phone.
Uploads 802.1X Client certificate to the phone; or delete existed 802.1X
Client certificate from the phone.
Specifies the HTTP proxy URL for the phone to send packets to. The proxy
server will act as an intermediary to route the packets to the destination.
Specifies the HTTPS proxy URL for the phone to send packets to. The proxy
server will act as an intermediary to route the packets to the destination.
Enter host names that do not require a proxy to reach. Those names should
be separated by commas.
Defines the Layer 3 QoS parameter for SIP. This value is used for IP
Precedence, Diff-Serv or MPLS. The default value is 26.
Defines the Layer 3 QoS parameter for RTP. This value is used for IP
Precedence, Diff-Serv or MPLS. The default value is 46.
Enables auto configure for VLAN settings through DHCP. Disabled by
default.
Assigns the VLAN Tag of the Layer 2 QoS packets. The default value is 0.
Assigns the priority value of the Layer2 QoS packets. The default value is 0.
GXP21XX Administration Guide
P a g e | 69