Table of Contents
Advertisement
Adjusting the Distortion (AMP SIM)
In the AMP SIM section, you can adjust the amount of distortion.
1.
Press the [ZONE EFFECTS] button to make the indicator light.
2.
In the AMP SIM section, press the [ON] button to make the
indicator light.
The amp simulator will turn on/off each time you press the button.
3.
In the AMP SIM section, turn the [DRIVE] knob to adjust the
amount of distortion.
MEMO
You can assign tremolo and amp simulator to a pedal by editing the
Program Edit "Pedal" parameter.
In this case, if the SYSTEM setting "Control Destination" is set
to PROGRAM, you can control the tones whose zone setting
(ZONE EDIT) has a check mark for "TR/AMP (Tremolo/Amp Control
Destination). "
Switching the Tremolo Type and the AMP SIM Type
1.
While holding down the TREMOLO [ON/OFF] button or the AMP
SIM [ON/OFF] button, press the [INC] [DEC] buttons or turn the
value dial.
MEMO
For more about tremolo and amp simulator, refer to "Parameter
Guide (English)" (PDF). For details on how to obtain the PDF, refer to
"Obtaining PDF Manuals" on the front cover.
Adjusting the Levels of Each Frequency Range (EQUALIZER)
The RD-2000 is equipped with a five-band equalizer.
1.
Use the ZONE EFFECTS [SELECT] button to select "EQ."
2.
Press the [EQ ON] button to make the indicator light.
3.
Turn the knobs to adjust the levels in each range.
NOTE
Sounds may be distorted with certain knob settings. If this occurs,
adjust the Input Gain.
MEMO
5 You can specify that the equalizer settings do not change even
when you switch programs. In "system settings, " set EQ Mode
(p. 26) to "REMAIN. "
5 For details on the equalizer, refer to the "Parameter Guide
(English)" (PDF).
For details on how to obtain the PDF, refer to "Obtaining PDF
Manuals" on the front cover.
Controlling the Functions Assigned to the Knobs (ASSIGN)
Assigning functions to the knobs or the buttons
1.
Use the ZONE EFFECTS [SELECT] button to select "ASSIGN."
2.
Hold down the [SHIFT] button and turn one of the ASSIGN
[1]–[8] knobs. Or, hold down the [SHIFT] button and press the
ASSIGN [9] button.
The Assign1-9 screen appears. Here you can specify the functions that
are assigned to the ASSIGN [1]–[8] knobs and the ASSIGN [9] button.
Using a function that's assigned to a knob or button
1.
Use the ZONE EFFECTS [SELECT] button to select "ASSIGN."
2.
Turn the ASSIGN [1]–[8] knobs to adjust the depth of the effect.
By pressing the ASSIGN [9] button, you can switch the effect of the
assigned function.
NOTE
Each effect is applied only to the zone that's selected by SELECT.
If the SYSTEM setting "Control Destination" is set to PROGRAM,
operating the various ASSIGN knobs or the ASSIGN [9] button does
not apply an effect to zones whose zone setting (ZONE EDIT) "A1–A9
(Assign 1–9 Control Switch)" check box is not selected.
MEMO
Depending on the state of the selected program or tone, the
assigned function might not be supported, so that you might not
obtain the effect you expect.
The values that are recalled when you switch sounds will be either
the default values or the most recently-operated value.
Owner's Manual
17
Hide quick links:
Advertisement
Table of Contents
