Table of Contents
Advertisement
12
SERVICE WORK ON THE CHASSIS
12.33
Checking for chain dirt accumulation
Main work
–
Check throttle cable routing. (
–
Position the fuel tank and fit the two spoilers to the sides in front of the radiator
bracket.
–
Make sure that no cables or throttle cables are trapped or damaged.
–
Attach the fuel tank breather hose.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
K00556-10
–
Position the horn with the horn bracket.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
K00558-11
–
Plug in connector
–
Remove the wash cap set.
–
Thoroughly clean the plug-in connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve!
–
Lubricate the O-ring and connect plug-in connection
E00509-10
Info
Route the cable and fuel line at a safe distance from the exhaust system.
Finishing work
–
Mount the seat. (
–
Check the chain for coarse dirt accumulation.
»
If the chain is very dirty:
–
Clean the chain. (
400678-01
p. 70)
with the rubber bushing.
M6
with the collar bushings.
M6
for the fuel pump.
p. 58)
p. 66)
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
for the fuel line.
65
Advertisement
Table of Contents
