KTM 350 EXC-F 2017 Owner's Manual page 106

18 SERVICE WORK ON THE ENGINE
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten oil drain plug
Guideline
Oil drain plug with magnet
K00570-10
–
Remove screws
K00571-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surface.
K00572-10
– Lay the motorcycle on its right side and fill the oil filter housing approx. ⅓ full with
engine oil.
–
Place the oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
K00573-10
–
Remove filler plug
oil.
Engine oil
401955-12
Info
Too little engine oil or poor-quality engine oil results in premature wear of
the engine.
–
Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and death.
–
–

with the O-ring.

with the magnet and a new seal ring.

. Remove the oil filter cover with the O-ring.

out of the oil filter housing.

with the O-ring from the clutch cover and fill up with engine
1.0 l (1.1 qt.)
Always make sure there is sufficient ventilation when running the
engine.
Use an effective exhaust extraction system when starting or running the
engine in an enclosed space.
M20x1.5 15 Nm
(11.1 lbf ft)
M12x1.5 20 Nm
(14.8 lbf ft)

M6 10 Nm (7.4 lbf ft)
Engine oil (SAE 10W/50) (
Alternative engine Engine oil
oil for harsh oper- (SAE 10W/60)
ating conditions (00062010035)
and increased per- ( p. 117)
formance
104
.
p. 117)