Table of Contents
Advertisement
12
SERVICE WORK ON THE CHASSIS
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Secure wiring harness and clutch line with cable holder.
–
Position the voltage regulator, and mount and tighten screws
Guideline
Remaining screws, chassis
K00548-11
–
Position the fork legs.
Bleeder screws
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
H01672-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
V00464-10
–
Tighten screw
Guideline
Screw, top steering head
V00465-11
–
Tighten screw
Guideline
Screw, top steering stem
V00465-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Secure the wiring harness with cable holder
V00464-11
but do not tighten yet.
are positioned toward the front.
.
.
.
.
.
M6
10 Nm (7.4 lbf ft)
M8
15 Nm
(11.1 lbf ft)
M20x1.5
12 Nm (8.9 lbf ft)
M8
20 Nm
(14.8 lbf ft)
M8
20 Nm
(14.8 lbf ft)
.
54
Advertisement
Table of Contents
