Inspecting Burners - Superior TF18NE Installation And Operation Instructions Manual

Unvented (vent-free) gas log heaters
Table of Contents

Advertisement

The touch pad has:
1. Led display
2. ON/OFF button
3. UP button
4. DOWN button
With this control it is possible to turn on the
fi re, turn off the fi re and control the fl ame level.
NOTE: The touch pad includes a red LED
display light. If the LED remains on, the black
plug is connected upside down. Unplug, turn
over, and reconnect.
LED Display
ON/OFF Button
UP Button
DOWN Button
Figure 53 - Touch Pad Control
SWITCHING ON
To turn the system on just press the ON/OFF
button. The system will emit a beep and begin
the ignition process, which can take about
20 seconds. Once the start up process is
complete, the pilot fl ame is lit.
REGULATING THE FLAME LEVEL.
1. To increase the fl ame level, press the
up button (
). A beep and a fl ash of
the LED indicate that the system has
accepted the order, and the fl ame will
increase instantly (see Figure 59).
2. To decrease the fl ame level, press the
down button (
). A beep and a fl ash of
the LED indicate that the system has
accepted the order, and the fl ame will
decrease instantly (see Figure 59).
SWITCHING OFF
To switch off the fi re, the ON/OFF button
should be pressed. After the system has emit-
ted a beep, the fi re switches off.
30
INSTALLATION
Continued
appliance to use different fuel
type. Only use appliance with
fuel type specifi ed.

INSPECTING BURNERS

Check pilot fl ame pattern and burner fl ame
patterns often.
PILOT FLAME PATTERN
Figure 54 shows a correct pilot fl ame pattern.
Figure 55 shows an incorrect pilot fl ame pat-
tern. The incorrect pilot fl ame is not touching
the thermocouple. This will cause the thermo-
couple to cool. When the thermocouple cools,
ON
the appliance will shut down.
OFF
If pilot fl ame pattern is incorrect, as shown
in Figure 55.
• turn appliance off (see To Turn Off Gas to
Appliance, Page 24
• see Troubleshooting, Page 33
NOTE: The pilot fl ame on natural gas units will
have a slight curve, but fl ame should be blue
and have no yellow or orange color.
Thermocouple
Figure 54 - Correct Pilot Flame Pattern
(Your pilot may vary from pilots shown)
Thermocouple
Figure 55 - Incorrect Pilot Flame Pattern
(Your pilot may vary from pilots shown)
SuperiorFireplaces.US.com
WARNING: Do not convert
Pilot Burner
Pilot Burner
126818-01C

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tf18peTf2430neTf2430pe

Table of Contents