VARIABLE REMOTE MODELS OPERATION
To activate this function, press THERMOSTAT
button until the word SMART appears to the
right of temperature bulb graphic on display.
Use UP/DOWN arrow button to set desired
room temperature. The control system will
cycle the fi replace on or off to maintain se-
lected temperature.
SMART
MAX
Figure 46 - Smart Thermostat Setting
CHILD SAFETY LOCK-OUT
This function lets you deactivate the remote
control buttons. It is active when the lock icon
is lit on the display.
To activate, press MODE button and UP ar-
row button at the same time. To deactivate,
press again.
ON
Figure 47 - Child Safety Lock-Out
REPLACING HAND-HELD REMOTE
CONTROL ONLY
If your remote ever needs to be replaced you
will not need to replace the receiver.
To program receiver with a new hand-held
remote, insert a small pin or paper clip into
hole on receiver face plate marked PRG.
The receiver will beep 3 times to indicate it
is ready to accept a new remote transmitter.
Press the ON/OFF button on your remote
and the receiver will beep 4 times to confi rm
it receives commands from the new remote.
ON REMOTE OFF
Figure 48 - Programing Remote Control
to Receiver
900463-01A
Continued
Check pilot fl ame pattern and burner fl ame
patterns often.
PILOT FLAME PATTERN
Figure 49 shows a correct pilot fl ame pattern.
Figure 50 shows an incorrect pilot fl ame pat-
tern. The incorrect pilot fl ame is not touching
the thermocouple. This will cause the thermo-
couple to cool. When the thermocouple cools,
the appliance will shut down.
If pilot fl ame pattern is incorrect, as shown
in Figure 50
• turn appliance off (see To Turn Off Gas to
• see Troubleshooting, Page 32
PRG
To
Program
Receiver
SuperiorFireplaces.us.com
INSPECTING BURNERS
Appliance, Page 27
Thermocouple
Figure 49 - Correct Pilot Flame Pattern
Pilot Burner
Figure 50 - Incorrect Pilot Flame Pattern
NOTE: The pilot fl ame on natural gas units
will have a slight curve, but fl ame should be
blue and have no yellow or orange color.
Pilot Burner
Thermocouple
29