Kyocera FS-9120DN Service Manual page 53

FS-9120DN/9520DN
Maintenance
item No.
U144 Setting toner loading operation
Description
Sets toner loading operation after completion of printing.
Purpose
To set whether or not toner is loaded on the drum after low density printing. Normally no change is necessary
from the initial setting.
Method
1. Enter the maintenance mode and press the
2. Press the ENTER key. "?" will be displayed.
>Set Toner Mode
[U144] ? Mode2
3. Press the
Display
MODE0
MODE1
MODE2
Initial setting: MODE2
4. Press the ENTER key. The setting is set.
To keep the setting, press the CANCEL key.
U150 Checking sensors
Description
Displays the status of each sensor.
Purpose
To check if the sensors operate correctly.
Method
1. Enter the maintenance mode and press the
>Check Sensor >
[U150]
2. Press the
The status of each sensor will be displayed.
Display
Ton
WatTon
F-down
3. Turn on or off the switch to check the status of the sensor. 0: Off 1: On
>>Ton:0 WstTon:0
[150.1] F-down:0
1-4-20
or key to select the desired mode.
key to display the submenu screen.
Description
or key to display "U144".
Description
Toner not loaded
Toner not loaded
Toner loaded
or key to display "U150".
Switches
Toner container sensor (TCS)
Overflow sensor (OFS)
Paper full sensor (PFS)