Lubrication Intervals - Yamaha SR 500 Service Manual

LUBRICATION INTERVALS
Unit: km (ml)
Initial Therea.fter every
Item Rema.rks Type 500
1,500 3,000 3,000 6,000
(Recommended lubricantsl (3001 (1,0001
(2,000) (2,000) (4,0001
Engine oil Replace/Warm engine SAE 20W/40 type
0 0 0
before draining "SE" motor oil
Replace fi/ter element and
Oil filter/Oil dean oïl strainer/After
0 0
0
strainer installing start engine check
-
oilleaks
Controi/Meter
Apply thoroughly SAE lOW/30 motor oil
0 0 0
ca bles
Throttle grip/
Apply lightly Lithium base grease 0 0
Housing
Front forks
Orain completely-Check SAE 10W/30 type "SE"
0
specifications motor oil
Steering lnspect thoroughly/Pack Medium-weight wheel 12,000
bea rings moderately bearing grease (8,000)
Speedometer lnspect thoroughly/Pack
Lithium base grease
12,000
gear housing moderately (8,000)
Rear arm pivot shaft
Apply lightly Lithium base grease
12,000
(8,000)
Wheel bearings Do not over-pack
Medium-weight wheel 12,000
bearing grease (8,000)
Drive chain Clean and lube SAE lOW/30 motor oil Every 500 (300)
Brake pedal shaft Apply lightly lithium base grease
0 0
Change pedal shaft Apply lightly Lithium base grease
0 0
NOTE:----------------------------------------------------------------------------------------
1. When disassembling the master cylinder or caliper cylinder, replace the brake fluid.
Normally check the brake fluid level and add the fluid as required.
2. On the inner parts of the master cylinder and caliper cylinder, replace the oil seals every two years.
3 . Replace the brake hoses every four years, or if cracked or damaged.
4