Client Qos Status - Linksys LAPAC1750PRO User Manual

LAPAC1750PRO Access Point Software User Manual
Mark Class of Service
Mark IP DSCP
Mark IP Precedence
Disassociate Class Map
Member Classes
Delete Policy Map
To delete a Policy Map, select the Delete Policy Map option and click Save
Select this field to mark all packets for
the associated traffic stream with the
specified class of service value in the
priority field of the 802 1p header If
the packet does not already contain
this header, one is inserted The CoS
value is an integer from 0–7
Select this field to mark all packets for
the associated traffic stream with the
IP DSCP value you select from the list
or specify
Select from List
Select from a list of DSCP types.
Select this field to mark all packets for
the associated traffic stream with the
specified IP precedence value The IP
precedence value is an integer from
0–7
Select this option and click Save to
remove the class selected in the Class
Map Name menu from the policy
selected in the Policy Map Name
menu
Lists all DiffServ classes currently
defined as members of the selected
policy If no class is associated with
the policy, the field is empty
Select this field to delete the policy
map showing in the Policy Map
Name menu
Section 3: Configuring the Access Point

Client QoS Status

The Client QoS Status page shows the client QoS settings that are applied to
each client currently associated with the AP
To view QoS settings for an associated client, click the Configuration > QoS and
Access Control > Client QoS Status tab
Figure 41: Client QoS Status
Table 49: Client QoS Status
Field Description
Station
The Station menu contains the MAC address of each client
currently associated with the AP To view the QoS settings
applied to a client, select its MAC address from the list
QoS Mode Shows whether the QOS mode for the selected client is up
(enabled) or down (disabled)
Note: For the QoS Mode to be enabled on a client, it must be
globally enabled on the AP and enabled on the VAP the client
is associated with Use the Global Settings page to enable the
QoS Global Admin mode and the per-VAP QoS Mode
Bandwidth Shows the maximum allowed transmission rate from the
Limit Up
client to the AP in bits per second (bps) The valid range is
0–4294967295 bps
80