Email Alert Status; System Log - Linksys LAPAC1750PRO User Manual

LAPAC1750PRO Access Point Software User Manual

Email Alert Status

The Email Alert Status page provides information about the email alerts sent
based on the syslog messages generated in the AP
To view the Email Alert Operational Status, click the System Status > Email Alert
Status tab
To configure the email alerts, see "Email Alert" on page 23
Figure 11: Email Alert Status
Table 13: Email Alert Status
Field Description
Email Alert The Email Alert operational status The status is either Up
or Down The default is Down
Status
Number of The total number of emails sent so far The range is an
unsigned integer of 32 bits The default is 0
Email Sent
Number of
The total number of email failures so far The range is an
unsigned integer of 32 bits The default is 0
Email Failed
Time Since The time and date when the last email alert was sent The
AP uses the system time to report the information If an
Last Email Sent
email has not been sent since the device was reset, the
status is not sent
Section 2: Viewing Access Point System Status

System Log

From the System Log page, you can view the most recent system log generated
by this AP
To view the Email Alert Operational Status, click the System Status > System Log
tab
To configure the Log settings, see "Log Settings" on page 21
Figure 12: System Log
Table 14: System Log
Field Description
Time Settings The system time when the event occurred
Type Specify the type of the log messages to write to non-
volatile memory
• emerg — emergency
•
alert — alert
• crit — critical
• err — error
• warn — warning
• notice — notice
•
info — info
• debug — debug
Service The software component associated with the log
Description
Log content
18