Qos And Access Control - Linksys LAPAC1750PRO User Manual

LAPAC1750PRO Access Point Software User Manual
Certificate File Upload
Upload Select the method to use for uploading a certificate file to the
Method
AP, which is either HTTP/HTTPS (upload by Web browser) or
TFTP (upload by TFTP server)
Filename
Specify the path and filename of the certificate file:
• For HTTP uploads, click Browse to find the location where
the certificate file is stored Select the file to upload to the
access point Click Upload to initiate the file transfer
• For TFTP uploads, enter the filename, including the path,
of the certificate to upload to the access point
Server
The IPv4 or IPv6 address of the TFTP server where the file is
IP (TFTP
located The default is 0 0 0 0 After you specify the filename
Upload
and server IP, click Upload to initiate the file transfer
Only)
NOTE:
After you configure the settings on the 802 1X Supplicant page, you must
click Save to apply the changes Changing some settings might cause the
AP to stop and restart system processes If this happens, wireless clients
will temporarily lose connectivity We recommend that you change AP
settings when WLAN traffic is low
Section 3: Configuring the Access Point

QoS and Access Control

This section describes how to configure QoS settings that affect traffic from the
wireless clients to the AP By using the access point Client QoS features, you can
limit bandwidth and apply ACLs and DiffServ policies to the wireless interface
This section describes the following features:
• Global Settings
• ACL
• Class Map
•
Policy Map
• Client QoS Status
66