Table of Contents
Advertisement
Changing the Equipment Settings
Boot Menu
Boot Menu USB Setup
3
Security Setup
Storage Setup
Language Setup
System Setup
Item
USB
Speed
Soft Reset
Offline Receive Disable
Serial Number
Job Limitation
Make Secure
SD Card
Make Normal
SD Card
Reset Cipher
Key
Check File
System
Check All
Sectors
Enable SD Card Yes
Erase SD Card
Enable
Initialization
Language
Initialize
High Humid
Mode
Moisture
Control
Menu Lockout
Factory Default
Enable
Sets whether to enable USB I/F.
480Mbps
Sets the maximum transfer speed of USB I/F.
Disable
Sets whether to enable the Soft Reset
command.
Sets whether to enable the function that
keeps the data receivable state with no
change of the I/F signal in case an error
occurs.
Enable
Sets whether to enable the USB serial
number.
Off
Sets the limited job mode.
When the mode is set to [Encrypted Job],
printing data other than specified (only an
encrypted authentication print job can be
specified) is restricted. This item is displayed
only when the optional SD memory card is
installed to the printer.
(NULL)
Enables encryption of data saved on an SD
memory card.
(NULL)
Disables encryption of data saved on an SD
memory card.
(NULL)
Resets the cipher key used on an encrypted
SD memory card.
After this operation has been completed, all
data stored on the SD memory card cannot
be restored.
(NULL)
Resolves mismatch between the actual
(available) memory and the available memory
displayed and performs recovery of the
administration data (FAT information) for a
file system. This operation is applied to each
file system.
(NULL)
Performs recovery of the defective sector
information on SD memory card and resolves
mismatch between the actual (available)
memory and the available memory displayed.
If the printer is not able to turn on due to a
damaged SD memory card, selecting [No]
enables the printer to turn on as if there is
no SD memory card installed even if an SD
memory card is installed to the printer.
(NULL)
This item is displayed only when an SD
memory card is installed.
This function erases all data on the SD
memory card.
No
Disables any changes that involve
initialization of the block device (SD memory
card, flash memory).
(NULL)
Initializes the message file loaded on the flash
memory.
Off
Turns on/off the curl reduction mode.
Off
Sets whether to enable the condensation
control.
Off
Turns on/off the menu lockout function.
- 56 -
Description
Advertisement
Table of Contents
