Table of Contents
Advertisement
Alert When Error Occurs
1
Perform steps 1 to 6 in
P.104.
When an error or warning requiring notification is
selected, a window will display to specify the time
between error occurrence and sending the alert.
2
Specify the time before sending error
alerts and then click [OK].
If you specify a longer time, you are only notified
of persisting errors.
3
Click [OK].
4
Click [View a Summary of Current
Configuration] to check the current
settings, and then click [X] to close the
window.
You can also check the current settings of up to
two addresses on the main window. Select the
desired addresses to check from the list box.
5
Click [Submit].
The network card reboots to enable the new
settings.
"Periodic Alerts"
- 105 -
Changing Network Settings From the Web Page
Controlling Access Using IP
Address (IP Filtering)
You can control access to the printer using
IP addresses. You can set whether to allow
configuration or printing from the IP addresses
specified. By factory default, IP filtering is
disabled.
Note
● Be sure to specify the correct IP address. If you specify a
wrong IP address, you cannot access the printer using the
IP protocol.
● When you enable IP filtering, access by hosts that are not
specified in these steps is rejected.
Memo
● You can use only IPv4 for IP filtering.
1
Access the printer's web page and log in
as the administrator.
2
Select [Admin Setup].
3
Select [Network Setup]>
[Security]>[IP Filter].
4
Follow the on-screen instructions to
specify detailed settings.
Note
● If nothing is registered in [Administrator IP
Address that has been registered], you may
not be able to access the printer depending on the
specified IP address range.
● If you use a proxy server, [Your Current Local
Host/Proxy IP Address] and the IP address of
your host may not match.
5
Click [Submit].
The network card reboots to enable the new
settings.
5
Advertisement
Table of Contents
