Network Settings; Dhcp Network Setup - Planar ultrares User Manual

Network Settings

DHCP Network Setup

Note:
Turn on the display.
1
Open the UltraRes Control tool and connect to the display.
2
Select the Info tab. The IP address is shown towards the bottom of the tab.
3
One of the following will occur:
4
• If the IP address is 192.168.12.12, then DHCP failed. Use the Static IP
Network Setup instructions in the following section.
Fast Startup mode is required if you are using the network connection.
Planar UltraRes User Manual
DHCP Network Setup
80