Epson SC-P5000 SERIES User Manual page 35

Hide thumbs Also See for SC-P5000 SERIES:
Table of Contents

Advertisement

SC-P5000 Series
User's Guide
G
Feed the paper.
When Auto Roll Feeding is On
When the paper is inserted a little, the screen
display changes to Press the Y button.
Check that the screen display has changed, and
then press the Y button to automatically feed
the paper to the start position.
When Auto Roll Feeding is Off
Insert the paper (so that the edge of the paper
comes out of the front manual feeder) until the
screen display changes.
Check that the screen display has changed, and
then press the Y button to automatically feed
the paper to the start position.
Note:
When Auto Roll Feeding is set to On, and a
paper cassette is specified from the printer driver,
the roll paper automatically returns to its standby
position and the cut sheet is fed and printed from
the paper cassette, even if the roll paper was
loaded on the printer.
The factory setting for Auto Roll Feeding is On.
H
Close the roll paper cover.
Proceed to step 9 if loading roll paper on which
there is no printed bar code.
Proceed to step 10 if loading roll paper on
which there is a printed bar code.
I
Check the media type.
Are these settings OK? is displayed on the
screen, and the media type currently specified
on the printer is displayed.
When the displayed media type and the loaded
media type match, press the d/u buttons to
select Yes, and then press the Z button.
Basic Operations
If you want to change the media type, select No
and then press the Z button. When the Paper
Type Menu is displayed, select the category
according to the loaded media type, and then
press the r button. Select the media type, and
then press the Z button.
J
Slide the output tray out to the second and
third extensions.
Do not raise the flap. If the flap is raised while
printing, the paper may not be ejected correctly.
c
Important:
❏ The output tray can only hold one sheet
of roll paper at a time. Remove each
sheet of roll paper as it is ejected without
letting the sheets stack up on the output
tray. Also, do not allow cut sheets and
roll paper to stack up together.
❏ Do not raise the flap when Roll Paper/
No Cut is set from the Paper Type Menu
or while performing banner printing. If
the flap is raised while printing, the
paper may not be ejected correctly.
K
Raise the paper eject support depending on the
paper type.
Raise the paper eject support when plain paper
is loaded.
35

Advertisement

Table of Contents
loading

Table of Contents