M.2 Ssd Enablement Option - HP ProLiant DL120 Gen9 User Manual

Align the PCI riser board with the corresponding connector on the system board, and then press down
8.
the riser cage.
Tighten the two screws to secure the cage.
9.
IMPORTANT:
Install the access panel (on page 21).
10.
Install the server into the rack
11.
Power up the server (on page 17).
12.

M.2 SSD enablement option

To install the component:
Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 17).
o
Remove the server from the rack (on page 19).
o
Remove the access panel (on page 20).
4.
Remove the PCI riser cage (on page 23).
5.
Install the SSD module on the M.2 SSD enablement board:
6.
Insert the SSD module into the SSD slot at a 45 degree angle, and then gently press it down against
a.
the M.2 SSD Enablement board.
Secure the SSD module to the M.2 SSD enablement board with a screw.
b.
Repeat the process if you are installing a second SSD module.
c.
The server does not power up if the PCI riser cage is not seated properly.
("Installing the server into the rack" on page 31).
Hardware options installation 67