Konica Minolta VIVID 9i/VI Instruction Manual page 32

Replacing the Lens and Field Calibration
3
Hold the external edge of the fixing ring and
pull it out.
M
emo
Hold the ring with your finger located near the red mark on
the lens. This will facilitate pulling the lens.
N
ote
Attach the lens cap to the removed lens, place it in the lens
case and keep it in a safe place.
The following information will appear in the viewfind-
er as shown on the right.
4
Attach the desired lens.
• Remove the lens cap.
• Align the red mark on the lens with the one on the
lens mount socket, and insert the lens until a click is
heard.
M
emo
Hold the ring with your finger located near the red mark on
the lens. This will facilitate inserting the lens.
5
Turn the lens fixing ring clockwise to secure
the lens.
N
ote
After tightening the lens, make sure that the red mark on
the ring is aligned with the red mark on the body.
Tightening ring
Red mark
30
CHANGE LENS
S/N 2001005
PRESS ANY KEY
AND SCAN FIELD
CALIBRATION SYSTEM
Red
mark