Using Redial Key For "Last Number Redial; Group Rtp Paging; Streams) - Aastra 9480i User Manual

Configuring Incoming Intercom Settings
Aastra Web UI
Use the following procedure to configure incoming intercom call settings on the IP phone.
1. Click Basic Settings->Preferences->Incoming Intercom Settings.
2. The "Auto-Answer" field is enabled by default. The automatic answering feature is turned on for the IP phone for
answering Intercom calls. To disable this field, uncheck the box.
Note:
If the Auto-Answer field is not checked (disabled), the phone treats the incoming intercom call as a normal call.
3. The "Microphone Mute" field is enabled by default. The microphone is muted on the IP phone for Intercom calls
made by the originating caller. To disable this field, uncheck the box.
4. The "Play Warning Tone" field is enabled by default. If "Auto-Answer" is enabled, the phone plays a warning tone
when it receives in incoming intercom call. To disable this field, uncheck the box.
5. The "Allow Barge In" field is enabled by default. If "Allow Barge In" is enabled, the phone puts an active call on hold
and answers the incoming Intercom call. To disable this field, uncheck the box.
6. Click Save Settings.

Using Redial Key for "Last Number Redial"

The IP phone has an enhanced redial user interface that allows a user to quickly redial the last number that was dialed out
from the phone. You can:
• Press the REDIAL button twice to redial the last number dialed.
• Press the REDIAL button once, scroll the list of numbers, then press the REDIAL button again to dial the number that dis-
plays on the screen.
The "last number redial" feature for the Redial key is static and is not configurable.

Group RTP Paging

You can configure the phone to allow it to receive a Real Time Transport Protocol (RTP) stream from pre-configured multi-
cast address(es) without involving SIP signalling. This is called Group Paging on the IP phones. You can specify up to 5 mul-
ticast addresses that the phone listens for on the network. This feature is configurable using the Aastra Web UI only.
The 9480i in the local network listens for RTP on the pre-configured multicast address. The Phone displays the "Paging"
message to the phone's LCD. It uses the G711 uLaw CODEC for multicast RTP.
The recipient can drop the incoming page if required. The recipient can also set Do Not Disturb (DND) to ignore any
incoming pages.
For incoming RTP multicasts, the ringing display is dependant on the setting for the "Allow Barge-In" parameter. (See
"Allow Barge In" on page 163.) If this parameter is disabled, and there is no other call on the phone, then the paging is
automatically played via the default audio device.
If there is an existing call on the phone, the call initially displays in the ringing state. The user has the option to
accept/ignore the call. If the "Allow Barge-In" parameter is enabled, the RTP multicast call barges in, and any existing calls
are put on hold.
41-001382-00 REV01 – 06.2013
(receives RTP streams)
Additional Features
164