Settings\Sensor Calibration; Function Test; Quick Restart - IVT Rego 5101 Installation Manual

Settings

4.12 Settings\Sensor calibration

Setting
Sensor calibration
Sensor calibration
E11.T1
E10.T2
E4x.T3
Tab. 43 Sensor calibration

4.13 Function test

Setting
Function test
Digital outputs
Analogue outputs
Tab. 44 Function test

4.14 Quick restart

Setting
Quick restart
Quick restart
Actual v.:
Tab. 45 Quick restart
26
Check the sensors and adjust the measurement value if necessary.
B
Do1 – Do7
Function:
Ao1 – Ao5
Function:
Manual value:
B Function test all inputs and outputs in conjunction with commissioning.
B Set Auto after completed test.
Otherwise an alarm occurs Output in wrong pos after function test (
page 34).
The control unit gives a recommended setting for each output in brackets on the fourth line of the
menu window.
Select Yes if the restart time for the compressor is to be changed from 10 minutes to 20
B
seconds.
The time remaining in seconds is shown.
Yes can only be selected when the restart timer is counting at 10 minutes. After changing, the
value automatically resets to No.
Factory
0.000 K
0.000 K
0.000 K
Factory
Auto
Auto
%
Factory
No
Display
Range HP
E21
E21
E2x HW
Range
Off, On, Auto
Manual, Auto
Chapter 5.6.30,
Range
No, Yes
6 720 645 172 (2010/07) en
HP
E2x
E2x
HP
E2x