Adding media modules and devices
There is no configuration necessary when you add or remove a WAN module. Configuration is
only necessary when you add WAN lines to the new module. See
page 91.
Adding a LAN device
You must connect, configure and test the LAN device before adding the device to the Avaya
G450 Media Gateway.
For instructions on connecting a new LAN device, see
port
on page 47.
Configuring the LAN device on the G450
Configuration may be performed on site by connecting a laptop computer to the CON port or
Services port of the G450, or remotely via a modem connected to the G450 or S8300.
For information about connecting a laptop to the Services port, refer to
to the Services port
Chapter 4: Connecting and enabling a modem for remote access
about configuration, refer to
Recording LAN information for software configuration
Before software configuration for the new LAN device takes place, gather the following
information:
The name and location of the owner of or person responsible for the LAN device
●
The slot and port number on the Avaya G450 Media Gateway to which the LAN device
●
connects. If the LAN device is connected to an IP telephone, note the extension of the
telephone to which the LAN device connects, and the slot and port number on the G450 to
which the telephone connects.
Testing the LAN device
After installation and configuration of the LAN device is complete, ping the IP address of the
device to test the device's connectivity within the network and outside the network.
88 Installation and Upgrades for the Avaya G450 Media Gateway
on page 48. For information about preparing a modem, refer to
Chapter 5: Configuring the G450
Adding a WAN line
Connecting a switch or a network data
Connecting a computer
on page 63. For information
on page 81.
on