Appendix - Toshiba ras-m16g3dv-e Service Manual

Lite-Vision plus Remote Controller (RB-RWS20-E) setup
1. Test run setup
<Procedure> Perform setting while the air conditioner stops.
Field setting menu
1.Test mode
2.Register service info.
3.Alarm history
4.Monitor function
5.FC setting
Return
Set
Field setting menu
1.Test mode
2.Register service info.
3.Alarm history
4.Monitor function
5.FC setting
Return
Set
Test mode
Test mode start.
Return
Yes No
(1)
Room A
Test
Cool
Mode Fan Speed
(2)
Room A
Test
(3)
Test mode
Test mode stop.
Return
Yes No
12:00
12:00

14. Appendix

1
Push the [ MENU] button to display the menu screen.
2
Push and hold the [
same time to display the "Field setting menu".
Push and hold the buttons for more than 4 seconds.
3
∧] / [
Push the [
"Field setting menu screen, then push the "
F2] button.
Pushing the "
the screen returns to the field setting menu screen.
Push [ CANCEL] twice, the screen (2) appears.
4
Push the [
screen (1) shown in the left appears. (The screen (2) appears
when the operation is stopped.)
Perform the test mode in the "Cool" or "Heat" mode.
Temperature setting cannot be adjusted during the test mode.
Check codes are displayed as usual.
5
When the test mode is finished, push the [
to select "1. Test mode" on the "Field setting menu" screen, then
push the "
Set
The screen (3) appears.
Pushing the "
screen and continues the normal operation.
NOTE
The test mode stops after 60 minutes and the screen returns to the normal / detailed
display.
– 88 –
MENU] button and the [
∨] button to select "1. Test mode" on the
Yes" [ F1] button sets the test mode and
Yes
ON / OFF] button to start the test mode. The
Set" [ F2] button.
Yes" [ F1] button stops the test mode
Yes
∨] button at the
Set" [
Set
∧] / [ ∨] button