Remote-A Or B Selection; Short Timer - Toshiba ras-m16g3dv-e Service Manual

Item
Setting the remote controller
15. Remote-A or
B selection
To separate using of remote control for each indoor unit
in case of 2 air conditioner are installed nearly.
Remote Control B Setup.
1) Press TEMPORARY button on the signal receiving
unit to turn the air conditioner ON.
2) Point the remote control at the signal receiving unit.
3) Push and hold CHECK • button on the Remote
Control by the tip of the pencil. "00" will be shown on
the display.
4) Press MODE • during pushing CHECK •. "B" will
show on the display and "00" will disappear and the
air conditioner will turn OFF. The Remote Control B is
memorized.
Note : 1. Repeat above step to reset Remote Control to
In the normal condition, after switching one circuit

16. Short Timer

breaker, 3-minute delay time for compressor is set for the
maintenance of the unit.
Operation flow and applicable data, etc.
be A.
2. Remote Control A has not "A" display.
3. Default setting of Remote Control from factory
is A.
S WING FAN
ONE-TOUCH F IX QUIE T
Hi POWER
C OMFOR T
S LE E P
1. Purpose
This operation is to operate only one
indoor unit using one remote controller.
2. Description
When operating one indoor unit in a
situation where two indoor units have
been installed in the same room or nearby
rooms, this operation prevents the remote
controller signal from being received
simultaneously by both units, thus
preventing both units from operating.
3. Operation
The indoor unit on which the remote
controller selection has been set to B
receives the signal of the remote controller
also set to B.
(At the factory the remote controller
selection is set to A on all the indoor units.
There is no A setting display.)
Purpose
To start the unit immediately for the purpose
of testing, trial...etc, short timer can be used.
maintenance of the unit.
Short Timer Setting
A Press [
B Set the operation mode on the remote
C Use the tip of the pencil to push the
4
D Press [
E When short timer is activated, all
3
– 36 –
Description
] button to turn the unit OFF.
control without sending the signal to
the unit.
[CHECK] button and hold, "00" will
show on display, then press [SET]
button to make "00" disappear.
] button to turn the unit ON.
setting on the remote operates
immediately, besides, all indications
on the signal receiving unit turns ON
continuously for 3 seconds.