Toshiba ras-m16g3dv-e Service Manual page 43

9. PRESET OPERATION
Set your preferred operation for future use. The setting will be memorized by the unit for future operation
(except air flow direction).
1. Select your preferred operation.
2. Press and hold
3. Press : Operate the preset operation.
10. AUTO RESTART OPERATION
To automatically restart the conditioner after the power failure (Power of the unit must be on.)
Setting
1. Press and hold the TEMPORARY button on the signal receiving unit for 3 seconds to set the operation
(3 beep sound and OPERATION lamp blink 5 time/sec for 5 seconds).
2. Press and hold the TEMPORARY button on the signal receiving unit for 3 seconds to cancel the operation
(3 beep sound but OPERATION lamp does not blink).
11. QUIET OPERATION
To operate at super low fan speed for quiet operation (except in DRY mode)
Press : Start and stop the operation.
QUIET
Note: Under certain conditions, QUIET operation may not provide adequate cooling due to low sound
features.
12. COMFORT SLEEP OPERATION
To save energy while sleeping, automatically control air flow and automatically turn OFF.
Press : Select 1, 3, 5 or 9 hrs for OFF timer operation.
Note: The cooling operation, the set temperature will increase automatically 0.5 degree/hour for 4 hours
(maximum 2 degrees increase).
13. SELF CLEANING OPERATION (COOL AND DRY OPERATION ONLY)
To protect bad smell caused by the humidity in the indoor unit.
1. If the button is pressed once during "Cool" or "Dry" mode, the fan will continue to run for other 30
minutes, then it will turn off automatically. This will reduce the moisture in the indoor unit.
If the time of "Cool" or "Dry" operation is less than 10 minutes, the self cleaning operation is not
performed.
2. To stop the unit immediately, press the
for 3 seconds to memorize the setting. The P mark displays.
more 2 times within 30 seconds.
– 42 –