Toshiba ras-m16g3dv-e Service Manual page 77

No. Part name
3 Electric parts box
cover
Procedure
1. Detachment
1) Perform step 1 of "2Terminal cover" as
required.
(You may be able to perform this procedure
without removing the electric parts box cover.)
2) Slightly loosen the screw holding the electric
parts box cover in place.
(Ø4×10 2 pcs)
3) Lifting the electric parts box cover upward, pull
the left side of the cover toward you to open it.
NOTE)
If it is difficult to open the electric parts box cover
because of the power supply and communication
cables connected to the cover, disconnect these
cables and perform the procedure.
4) Disconnect the following connectors from the
control P.C. board.
NOTE)
Unlock the lock of the housing to disconnect the
connectors.
CN41 ... Remote control connector (2P: Blue)
CN67 ... Power supply connector (5P: Black)
CN214...Signal receiving lead wire (9P: White)
5) Lift the electric parts box cover upward and pull
the cover to the left toward you to detach it
from the claws on the right side.
2. Attachment
1) Insert the hooking plates of the main body into
the hook holes on the right side of the electric
parts box cover.
2) Reconnect the cables that you disconnected in
step 1-4) of "3Electric parts box cover."
3) Moving the electric parts box cover downward,
close the electric parts box cover. Insert the
cover in the gap between the box and screws
that you loosened in step 1-2) of "3Electric
parts box cover" and use the screws to fix the
cover into place.
Screws
Control
P.C. board
Hooking
part
– 76 –
Remarks
Electric parts box cover