Furuno MU-151C Operator's Manual page 17

AutoAdjust
1. Operate the external equipment connected to the MU-151C to show the frame test
pattern. Refer to each manual for how to show the test pattern.
AutoAdjust is inoperative if the frame test pattern is not available. In this case, adjust the
timing manually.
2. Press the [MENU] key on the MU-151C.
3. Press [▲] or [▼] to select [AutoAdjust], and then press the [MENU] key.
"OK" or "ERROR" appears on the screen after a few seconds.
When "OK" appears, confirm that the corners of the frame are placed in respective
corners on the screen. If the frame is misaligned or "ERROR" appears, adjust the H
Total, H Position and V Position manually.
Confirm that small characters are shown clearly. If not, adjust the Phase.
AutoColor
1. Operate the external equipment connected to the MU-151C to show the white test
pattern. Refer to each manual for how to show the test pattern.
AutoColor is inoperative if the white test pattern is not available. In this case, adjust the
contrast manually.
2. Press the [MENU] key on the MU-151C.
3. Press [▲] or [▼] to select [AutoColor], and then press the [MENU] key.
"OK" or "ERROR" appears on the screen after a few seconds.
If "ERROR" appears, adjust the Contrast manually, observing the screen. When there is
a great difference in the contrast level among red, green and blue, adjust ContrastRed,
ContrastGrn and ContrastBlu.
Frame test pattern
White test pattern
9
White