Specifications - Rinnai Impressor 8 Operating And Assembly Instructions Manual

3
G E N E R A L
GAS INSTALLATION CODES
Australian Gas Association Certificate No. 6468.
Barbecues must be used in accordance with the
installation requirements of your local gas supply
authority, and the appropriate installation standard
AS5601/AG601.
Barbecues for use with cylinder gas are labelled
'Universal LPG'. Barbecues for use with natural gas
are labelled 'Natural Gas' and must be installed by an
authorised person. Check the gas type sticker attached
to the barbecue. Check that the label matches the gas
type to be used.
FAILURE TO COMPLY WITH THESE
!
INSTRUCTIONS COULD RESULT IN A
FIRE OR EXPLOSION WHICH COULD
CAUSE SERIOUS BODILY INJURY,
DEATH OR PROPERTY DAMAGE.
!
ACCESSIBLE PARTS MAY BE VERY HOT.
KEEP YOUNG CHILDREN AWAY.
ANY MODIFICATION OF THIS
APPLIANCE MAY BE DANGEROUS.
DO NOT MOVE THIS APPLIANCE
DURING USE.
TURN OFF THE GAS SUPPLY AT THE
GAS CYLINDER AFTER USE.
READ THE INSTRUCTIONS BEFORE
USING THE APPLIANCE.
PARTS SEALED BY THE
MANUFACTURER MUST NOT BE
MANIPULATED.
THIS BARBECUE IS ONLY TO BE USED
AND STORED OUTDOORS.
OVERALL DIMENSIONS
Height – Hood closed 1260 mm.
Hood open 1510 mm.
Width – 1900 mm
Depth – Hood closed 655 mm.
– Hood open 725 mm.
CLEARANCES
The following minimum clearances from combustible
materials must be maintained: Top – 1000 mm, rear –
450 mm and sides – 250 mm.
Openings at the rear and sides of the appliance
provide air for combustion, and must not be obstructed.
I N F O R M A T
HOSE AND REGULATOR SAFETY
!
The regulator and hose assembly supplied with the
barbecue is suitable for use with bottled gas.
A gas regulator adjusted to have an outlet pressure
of 2.75 kPa is supplied for connection to the gas cylinder.
The regulator and hose assembly supplied with the
appliance must be used. Replacement regulator and
hose assemblies must be those specified by the appli-
ance manufacturer.
When connecting the hose and regulator assembly
to the gas cylinder, take care to avoid unnecessary
twisting of the flexible hose. After the assembly has
been secured, turn on the gas and check for leaks by
brushing a soap and water solution over all visible and
accessible gas line connections. The presence of bubbles
will indicate a gas escape. DO NOT TEST FOR GAS
ESCAPES WITH AN OPEN FLAME.
If you are unable to correct the leak by tightening
the connection, turn off the gas and contact your place
of purchase immediately.
Always ensure the appliance is kept away from
flammable materials and the gas cylinder clear of any
heat source.
When changing over from an empty gas cylinder to
a full one, make sure this procedure is carried out in a
flame free atmosphere.
Inspect the gas hose when replacing the gas cylinder
or once a year whichever is more frequent. If the hose
is cracked, cut, abraded or damaged in any way, the
appliance must not be operated. The hose must be
replaced if damaged or when statutory conditions
require it. Contact your place of purchase if uncertain.
The POL fitting of the hose and regulator should be
disconnected from the gas cylinder valve when the
outdoor appliance is not in use.
!

SPECIFICATIONS

Appliance specifications can be found on the data label
attached to the rear panel of the barbecue body.
Your barbecue is preset at the factory to operate on
bottled gas only, unless specified otherwise.
I O
NEVER OPERATE THIS BARBECUE
WITHOUT A REGULATOR.
GAS HOSES ARE FACTORY FITTED AND
LEAK TESTED – DO NOT DISCONNECT.
3
N