Stamina EX 30 Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
Connection Wire from
the COMPUTER(25)
STEP 6:
To install the CONSOLE ASSEMBLY(26,27,28), run the two Connection Wires at each side of
the CONSOLE ASSEMBLY(26,27,28) through the LEFT and RIGHT UPRIGHTS(3, 4). And run the UPPER
CONNECTION WIRE(24) go into the CONSOLE ASSEMBLY(26,27,28). Insert the CONSOLE ASSEMBLY
(26,27,28) onto the LEFT and RIGHT UPRIGHTS(3, 4) and secure with SOCKET HEAD BOLTS
(M8x1.25x40mm)(104) and LOCK WASHERS(M8)(119).
STEP 7:
Refer to the inset drawing. Connect the UPPER CONNECTION WIRE(24) to the Connection
Wires from the COMPUTER(25). Arrange the wires for clearness, then press the BOTTLE HOLDERS(29)
into the CONSOLE ASSEMBLY(26,27,28) at the position as shown in the illustration.
STEP 8:
Tighten the SOCKET HEAD BOLTS(M8x1.25x25mm)(103) at both sides of the UPRIGHTS
(3, 4). Tighten the NYLOCK NUTS(M8x1.25)(114) at both sides of the FRONT BASE(2).
STEP 9:
There is a " - " mark on the LEFT HANDRAIL(30L), and a " + " mark on the RIGHT HANDRAIL
(30R). Connect the PULSE SENSOR WIRE(35) and CONNECTION WIRE(34) in the RIGHT HANDRAIL
(30R) to the connection wires from the COMPUTER(25). Insert the RIGHT HANDRAIL(30R) into the
RIGHT UPRIGHT(4) and secure with SOCKET HEAD BOLTS(M8x1.25x16mm)(102) and LOCK WASHER
(M8)(119). Repeat on the left side.
8