Console Port Access Commands - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
Term Definition
Network The network protocol being used. The options are bootp | dhcp | none.
Configuration
Protocol Current
Example: The following shows example CLI display output for the network port.
(admin) #show network
Interface Status............................... Always Up
IP Address..................................... 10.250.3.1
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.250.3.3
Burned In MAC Address.......................... 00:10:18:82:03:37
Locally Administered MAC Address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Network Configuration Protocol Current......... None
Management VLAN ID............................. 1
C P
ONSOLE ORT
This section describes the commands you use to configure the console port. You can use a serial cable to connect a
management host directly to the console port of the switch.
configuration
This command gives you access to the Global Config mode. From the Global Config mode, you can configure a variety of
system settings, including user accounts. From the Global Config mode, you can enter other command modes, including
Line Config mode.
Format
configuration
Mode Privileged EXEC
lineconfig
This command gives you access to the Line Config mode, which allows you to configure various Telnet settings and the
console port.
Format
lineconfig
Mode Global Config
serial baudrate
This command specifies the communication rate of the terminal interface. The supported rates are 1200, 2400, 4800, 9600,
19200, 38400, 57600, 115200.
Default 9600
Format
serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 115200}
Mode Line Config
© 2009 D-Link Corporation. All Rights Reserved
476
A C
CCESS OMMANDS