Using A Com Port To Connect To Dap-3690; Using A Terminal To Connect To The Console Port - D-Link DAP-3690 Reference Manual

Using a COM port to connect to DAP-3690

The back panel of the DAP-3690 provides an RJ45 Ethernet port to connect an RS-232 connector to your
PC for monitoring and configuration.
To use the console port, the following equipment is needed:
1. A terminal or a computer with both an RS-232 serial port and the ability to emulate a
terminal.
2. A console cable with a male DB-9 connector on one end and an RJ-45 connection on the
other. It establishes the physical connection to the console port.

Using a terminal to connect to the console port

Connect the male DB-9 connector on the console cable to the RS-232 serial port on the computer
running terminal emulation software then insert the RJ-45 connector into the RJ-45 console port on the
front of the Switch.
Set the terminal emulation software as follows:
Select the appropriate serial port (COM1 or COM2).
Set the data rate to 115200 baud.
Set the data format to 8 data bits, 1 stop bit, and no parity.
Set flow control to none.
Under Properties, select VT100 for Emulation mode.
Select Terminal keys for Function, Arrow and Ctrl keys. Make sure to use Terminal keys (not Windows
keys) are selected.
Telnet 192.168.0.50 on the command prompt