Section 6: Access Point Cli Commands; Configuring Basic Settings; Table 5: Basic Setting Commands - D-Link DWL-8600Ap Reference Manual

Se ction 6: Acc ess Po int CLI Comma nds
This section describes some of the commands you use to view and configure the UAP.
Note: This section does not describe every command available from the UAP CLI. The UAP is intended to be
configured primarily from the Web interface.
The CLI performs validation on individual property values in a
values are consistent with each other. For example, it would not provide any error if a radio's mode was set to "a" and its
channel was set to "1". (Even though "1" is not a valid channel in "a" mode, it is a valid channel in "g" mode.) In cases where
the configuration is left in an inconsistent state, the services associated with the configuration may not be operational.
Therefore, it is important to consult the class and property reference to understand the acceptable values for properties given
the values of other properties. For more information, see
C B
ONFIGURING
The following CLI command examples correspond to tasks you can accomplish on the Basic Settings tab of the Web UI for
access points.
Note: Before you configure the basic settings, make sure you are familiar with the names of the interfaces as
described in "Interface Naming Conventions" on page
determines whether a setting applies to a wired or wireless interface, the Internal network, or to radio "one" or radio
"two.
Action
View the following information about the
management interface on the AP:
• VLAN ID
• Interface name
• Static IP address (if DHCP is not used)
• Static subnet mask
• IP Address
• Subnet mask
• MAC address
• DHCP status
• IPv6 status
• IPv6 auto configuration status
• Static IPv6 address
• Static IPv6 prefix length
View the firmware version
View the serial number
S
ASIC ETTINGS

Table 5: Basic Setting Commands

Command
get management
get system version
get system serial-number
set or add , but does not check to see if different property
"CLI Classes and Properties Reference" on page
11. The interface name you reference in a command
Access Point CLI Commands
20.
13