Table of Contents
Advertisement
Default
enabled
Format
no monitor
Mode
Global Config
show monitor session
This command displays the Port monitoring information for a particular mirroring session.
Note: The <session-id> parameter is an integer value used to identify the session. In the current version of
the software, the <session-id> parameter is always one (1).
Format
show monitor session <session-id>
Mode
Privileged EXEC
Term
Definition
Session ID
An integer value used to identify the session. Its value can be anything between 1 and the maximum
number of mirroring sessions allowed on the platform.
Monitor Session
Indicates whether the Port Mirroring feature is enabled or disabled for the session identified with
Mode
<session-id>. The possible values are Enabled and Disabled.
Probe Port
Probe port (destination port) for the session identified with <session-id>. If probe port is not set then
this field is blank.
Source Port
The port, which is configured as mirrored port (source port) for the session identified with <session-
.
id>
Type
Direction in which source port configured for port mirroring.Types are tx for transmitted packets and rx
for receiving packets.
S
MAC F
TATIC
The commands in this section describe how to configure static MAC filtering. Static MAC filtering allows you to configure
destination ports for a static multicast MAC filter irrespective of the platform.
macfilter
This command adds a static MAC filter entry for the MAC address <macaddr> on the VLAN <vlanid>. The value of the
<macaddr> parameter is a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The restricted MAC Addresses
are: 00:00:00:00:00:00, 01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and
FF:FF:FF:FF:FF:FF. The <vlanid> parameter must identify a valid VLAN.
The number of static mac filters supported on the system is different for MAC filters where source ports are configured and
MAC filters where destination ports are configured.
•
For unicast MAC address filters and multicast MAC address filters with source port lists, the maximum number of static
MAC filters supported is 20.
•
For multicast MAC address filters with destination ports configured, the maximum number of static filters supported is
256.
If no source port is configured for the session then this field is blank.
ILTERING
Static MAC Filtering
95
Advertisement
Table of Contents
