Spanning Tree Protocol Commands - D-Link DWS-4000 Series Cli Command Reference

D-Link Unified Switch CLI Command Reference
S T
PANNING REE
This section describes the commands you use to configure Spanning Tree Protocol (STP). STP helps prevent network loops,
duplicate messages, and network instability.
Note: STP is disabled by default. When you enable STP on the switch, STP is still disabled on each port.
Note: If STP is disabled, the system does not forward BPDU messages.
spanning-tree
This command sets the spanning-tree operational mode to enabled.
Default disabled
Format
spanning-tree
Mode Global Config
no spanning-tree
This command sets the spanning-tree operational mode to disabled. While disabled, the spanning-tree configuration is
retained and can be changed, but is not activated.
Format
no spanning-tree
Mode Global Config
spanning-tree bpdufilter
Use this command to enable BPDU Filter on the interface.
Default disabled
Format
spanning-tree bpdufilter
Mode Interface Config
no spanning-tree bpdufilter
Use this command to disable BPDU Filter on the interface.
Default disabled
Format
no spanning-tree bpdufilter
Mode Interface Config
spanning-tree bpdufilter default
Use this command to enable BPDU Filter on all the edge port interfaces.
© 2009 D-Link Corporation. All Rights Reserved
18
P C
ROTOCOL OMMANDS