Table of Contents
Advertisement
M2488 USER'S GUIDE
FIGURE AND
INDEX NO.
3-7
1
Message Display
2
Tape Position LEDs
3
DOORLOCK LED
4
POSITION pushbutton
5
MODE SEL. pushbutton
PUSH switch
6
7
RESET pushbutton
8
TEST pushbutton
9
SHIFT pushbutton
10
UNLOAD pushbutton
11
START pushbutton
12
Magazine Position indictor
13
SYSTEM LED
14
AUTO LED
15
MANUAL LED
16
COMP LED
17
ATTN. LED
18
SEL LED
April 1997
Table 3-7. FACL Front Panel Controls and Indicators
CONTROLS AND
INDICATORS
CG00000-011403 REV. A
CONTROLS AND INDICATORS
DESCRIPTION
Displays the background, host, fixed, not-ready, check or con-
figuration messages with eight alphanumeric characters, includ-
ing symbols.
Indicates tape position between BOT and EOT. Lights illumi-
nate sequentially in the forward direction (wrap 1) and turn off
sequentially in the reverse direction (wrap 2).
Illuminates to indicate the front panel door is locked.
This pushbutton operates only in manual mode.
Press to do one of the following:
1. select a start point in the magazine.
2. select the cleaning cartridge.
Press to change the FACL mode to system, auto or manual.
Push to open and push to close door.
Press to select the tape drive not-ready state and the FACL stop
state.
Press to reset an error display.
Pressed with the UNLOAD pushbutton to enter or exit the
offline (menu) mode. Press to display additional messages.
Press with the START pushbutton in the test mode.
Press to manually unload and eject cartridge into magazine.
Press only during a not-ready or error state.
Press to do one of the following:
1. mount the magazine, if inserted.
2. cause the autoloader to go from a stop status to a start status
(DOORLOCK LED illuminates).
3. load the tape cartridge from the current position.
Displays numbers or letters to indicate magazine position or
state of the FACL.
Illuminates to indicate the FACL is in the SYSTEM mode.
Illuminates to indicate the FACL is in the AUTO mode.
Illuminates to indicate the FACL is in the MANUAL mode.
Illuminates when data compression is selected.
When a mount/demount message is received from the host sys-
tem, the ATTN LED blinks to prompt the operator to mount the
cartridge/magazine.
Illuminates when the tape drive is selected on the SCSI bus.
3-9
Advertisement
Table of Contents
