Table 4-4. S.ft2 Bit Description; Table 4-5. S.ft3 Bit Description; Table 4-6. S.ft4 Bit Description - Fujitsu m2488 User Manual

M2488 USER'S GUIDE
BIT
0-3
4-7
BIT VALUE
0-7
BIT VALUE
0-2
3
4
April 1997

Table 4-4. S.FT2 Bit Description

VALUE
Reserved
Sets cleaning cartridge counter (FACL only).
0xh 500 times (default)
2xh 200 times
4xh 400 times
6xh 700 times
8xh 900 times
Axh 1100 times
Cxh 1300 times
Exh 1500 times

Table 4-5. S.FT3 Bit Description

1 Reserved

Table 4-6. S.FT4 Bit Description

Reserved
1 Support ANSI SCSI-3 Write Buffer modes 6 and 7. Reference the Write Buffer com-
mand description in the M2488 for a description of Write Buffer modes 6 and 7.
0 Write Buffer modes 6 and 7 are reserved (per ANSI SCSI-2).
1 For SCSI commands which require access to tape or the data buffer, Busy status is not
generated when the command is received for an ITL nexus which is currently processing
previously issued immediate SCSI command. The new SCSI command is held (following
a disconnect, if allowed) , then processed after the current immediate operation under
way has completed.
NOTES:
1) This feature is similar to FT4, bit 5 defined below, except for sense key 2 (Not Ready)
with ASC/ASCQ 0401 (LUN is in process of becoming ready) not being generated.
2) If FT4, bit 4 and FT4, bit 5 are both set, then the FT4, bit 4 feature takes precedence.
0 Busy status is generated when a SCSI command, which requires access to tape or data
buffer, is received for an ITL nexus currently processing a previously issued immediate
SCSI command.
CG00000-011403 REV. A
DESCRIPTION
1xh 100 times
3xh 300 times
5xh 600 times
7xh 800 times
9xh 1000 times
Bxh 1200 times
Dxh 1400 times
Fxh 1600 times
DESCRIPTION
DESCRIPTION
CONFIGURATION
4-5