Table 3-1. M2488 Front Panel Controls And Indicators - Fujitsu m2488 User Manual

CONTROLS AND INDICATORS
FIGURE AND CONTROLS AND
INDEX NO.
3-1
1 ATTN LED
2 Cartridge Slot
3 Tape Position LEDs
4 Message Display
5 RESET push-button
6 UNLOAD push-button
7 START push-button
8 TEST push-button
SHIFT push-button
9
10 COMP LED
11 SEL LED
12 Air filter
3-2

Table 3-1. M2488 Front Panel Controls and Indicators

INDICATORS
When a mount/demount message is received from the host system, the
ATTN LED blinks to prompt the operator to mount the cartridge.
Cartridge opening.
Indicates tape position between BOT and EOT. Lights illuminate
sequentially in the forward direction (wrap 1) and turn off sequentially
in the reverse direction (wrap 2).
Displays the background, host, fixed, not-ready, check or configuration
messages with eight alphanumeric characters, including symbols.
Press to select the not-ready state, or reset check conditions.
Press to unload tape cartridge when in the not ready state.
Press to make drive ready when in the not ready state.
Pressed with the UNLOAD push-button to enter the offline (menu)
mode.
Press to display additional messages.
Press with the START push-button in test mode.
Illuminates during all write operations. Illuminates during all 36-track
reads and during 18-track reads if the compression bit is set in the
block ID for the data read. The compression LED will be off if the last
18-track block read is not compressed data.
Illuminates when the tape drive is selected on the SCSI bus.
Replaceable air filter.
CG00000-011403 REV. A
M2488 USER'S GUIDE
DESCRIPTION
April 1997