Environmental Information; Table 1-6. Environmental Specifications - Fujitsu m2488 User Manual

INTRODUCTION
1-11

ENVIRONMENTAL INFORMATION

Table 1-6 describes the operational environment for the M2488 tape drive.
SPECIFICATION
Operating:
Tape Drive
Temperatures
Humidity
Altitude
Vibration*
Shock**
* Cycle: 10mm/cycle log sweep, 3 axes
** Half sine pulse (+/-), 3 axes
Tape Cartridges
Temperatures
Humidity
NOTE: Acclimate the tape cartridge to the machine room environment for 24 hours prior to use.
Remove cartridge from drive if temperature exceeds 32° C for more than 12 hours.
The applicable proposed ANSI specification for half-inch tape cartridge requires operation in the range of 16°C to 32°C,
20% relative humidity and maximum wet bulb temperature of 25.6°C. Operation of this device beyond these limits may
result in a degradation of media reliability.
Magazine
Temperatures
Humidity
Non-Operating
Tape Drive
Temperatures
Humidity
Altitude
Vibration*
Shock**
* Cycle: 10mm/cycle log sweep, 3 axes
** Half sine pulse (+/-), 3 axes
Note 1: Drive operation, under cartridge environment which exceeds the ANSI standard, may cause degradation of
media reliability.
Do not operate in the environment for many hours.
ANSI standard operation:
Temperature 16 ° C to 32 ° C; Humidity 20 to 80%;
Note 2: Acclimate the tape cartridge to the machine room environment for 24 hours prior to use.
1-8

Table 1-6. Environmental Specifications

10 ° to 40 ° C, 50° to 104 ° F
29 ° C maximum wet bulb temperature; 15° C/hour maximum rate-of-change
20 to 80%
0 to 3050 m, 0 to 10,000 feet
5 -10 Hz: 0.13 mm; 10 - 200 Hz: 0.25 G
4 G, 10 ms maximum.
0 ° to 50 °C, 32 ° to 122 ° F
8 to 95%
0 ° to 50 ° C, 32 ° to 122 ° F
8 to 95%
0 ° to 50 ° C, 32 ° to 122 ° F
8 to 95%
not specified
5 - 8 Hz: 3.8 mm; 8 - 32 Hz: 0.5 G
32 - 55 Hz: 0.25 mm; 55 - 200 Hz: 1.5 G
20 G, 10 ms maximum.
CG00000-011403 REV. A
REQUIREMENT
Maximum Wet Bulb 25.6 ° C
M2488 USER'S GUIDE
April 1997