Kohler l654 Service Manual page 25

Figure 6-13. Over Bolt Removal (Two Shown)
11. Lift the brushes by the leads and lock in this position
by inserting a retainer wire as shown in Figure 6-12.
12. Remove the end bracket by removing four long over
bolts. See Figure 6-13.
13. Disconnect the stator leads from the regulator.
NOTE
The voltage regulators on 4.5, 5.5, 7 and 7.5kW
generator sets are located inside the end bracket.
On the 3.5kW, the voltage regulator is located
outside the end bracket. See Figures 6-14 and
6-15. Terminal connections and testing will be
the same for all.
Figure 6-14. Exciter / Voltage Regulator
Figure 6-15. Exciter / Voltage Regulator (3.5KW)
14. The stator (Figure 6-16) can be tested at this time (Sec-
tion 6-8). Remove the stator by guiding it to the rear,
15.1
l
Four-Pole Removal (4.5, 5.5,7,7.5kW). Remove thru
bolt and detach washers. Re-insert thru bolt leaving a l/8
6-4