Panasonic KX-NS500 Pc Programming Manual page 408

9.31 PBX Configuration—[1-1] Configuration—Slot—Port Property—E1 Port
CO Dial Mode
Selects the type of signal used to dial out to a trunk.
If MFC-R2 is selected, the PBX (not the telephone company) sends a dial tone to the caller when making a
trunk call using an E1 line.
Value Range
DTMF, MFC-R2
Maintenance Console Location
9.31 PBX Configuration—[1-1] Configuration—Slot—Port Property—E1 Port
Feature Guide References
2.5.4.4 Dial Type Selection
2.29.1 E1 Line Service
E1 Receiver Type
Selects the type of signal the PBX receives from the E1 line.
This should be set to MFC-R2 when receiving ANI (Automatic Number Identification) numbers from the E1
line.
Value Range
DTMF, MFC-R2, Undefined
Maintenance Console Location
9.31 PBX Configuration—[1-1] Configuration—Slot—Port Property—E1 Port
Feature Guide References
2.29.1 E1 Line Service
Receive Digits
Specifies the maximum number of digits to be received from a DDI/DID number when receiving a call with the
DDI/DID number.
Value Range
0–15
Maintenance Console Location
9.31 PBX Configuration—[1-1] Configuration—Slot—Port Property—E1 Port
CPC Detection Time—Out, In
Specifies the length of time required by the PBX to detect a CPC signal on outgoing or incoming trunk calls
before disconnecting the line. When None is selected here, the line will not be disconnected when a CPC signal
is not detected.
408 PC Programming Manual