IBM RS/6000 7043 43P Series Service Manual page 218

SCSI Cable System
Location
Connector 1 System Board,
J4
Connector 2 Bay 2, CD-ROM
Connector 3 Bay 3, Lower
Media
Connector 4 Bay 4, Uppser
DASD
Connector 5 Bay 5, Lower
DASD
Connector 6 System Board,
J33
Diskette Drive
Removal
1. Unplug the diskette power and signal cables from the back of the drive.
2. Remove the screws which secure the diskette drive to the media drive bracket.
Replacement:
Replace in reverse order.
8-14
7043 43P Series Service Guide
Cable Notes
Between Connectors 1 and 2, route over power supply, not
under CD-ROM.
If empty, route extra cable through clamp above power
supply.
If empty, route extra cable through clamp above power
supply.