IBM RS/6000 7043 43P Series Service Manual page 103

Table 3-2 (Page 4 of 9). Firmware Error Codes.
Error Code Description
002 Test Unit Ready Failed - sense data
available
003 Send Diagnostic Failed
004 Send Diagnostic Failed - DevOfl cmd
21E00xxx SCSI Tape
21ED0xxx SCSI Changer
21EE0xxx Other SCSI device type
21F00xxx SCSI CDROM
21F20xxx SCSI Read/Write Optical
25010xxx Flash
xxx=000 No diskette in drive
001 Diskette seek error
002 Diskette in drive does not contain an
*.IMG file.
003 Cannot open OPENPROM package
004 Cannot find OPENPROM node
006 System id does not match image
system id
007 Image has bad CRC
008 Flash is write protected, update
cancelled
009 Flash module is unsupported or not
recognized
Chapter 3. Error Code to FRU Index for Model 140 and Model 240
Action/
Possible Failing FRU
1. Media (Removable media devices)
2. SCSI device
1. SCSI device
1. SCSI device
Refer to 21A00xxx (SCSI disk drive) for
xxx definitions
Refer to 21A00xxx (SCSI disk drive) for
xxx definitions
Refer to 21A00xxx (SCSI disk drive) for
xxx definitions
Refer to 21A00xxx (SCSI disk drive) for
xxx definitions
Refer to 21A00xxx (SCSI disk drive) for
xxx definitions
Insert diskette containing firmware
image.
1. Retry function
2. Replace diskette drive
3. Replace diskette cable
4. Replace system board (See notes
on page 3-1.)
Insert diskette with firmware update file.
Replace system board. (See notes on
page 3-1.)
Replace system board. (See notes on
page 3-1.)
Make sure correct firmware update
diskette is being used with this system.
Replace firmware updated diskette
1. Turn off, turn on system unit and
retry.
2. Replace system board. (See notes
on page 3-1.)
Make sure correct firmware update
diskette is being used with this system.
3-7