Power Supply - IBM RS/6000 7043 43P Series Service Manual

Power Supply

DANGER
Do not attempt to open the covers of the power supply. Power supplies
are not servicable and are to be replaced as a unit.
Removal
1. Unplug all power cords (cables) from electrical outlets.
2. If you have not already done so, remove the cover as described in "Cover" on
page 8-3.
3. Disconnect the power supply cables from the system board connectors and any
installed drives.
4. Remove the rear bezel from the system unit by releasing the three latches and
swinging the bezel away from the right side of the system unit.
8-6
7043 43P Series Service Guide