Installing The Intrusion Switch - Dell DL1300 Owner's Manual

Figure 10. Removing the intrusion switch
1. intrusion switch
3. intrusion switch cable
5. cable routing clip (2)
Next steps
1. Install the intrusion switch.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Before working inside your system
After working inside your system
Safety instructions

Installing the intrusion switch

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Insert the intrusion switch into the intrusion switch slot.
2. Slide the intrusion switch until it locks into position.
3. Route the intrusion switch cable through the cable routing tab.
2. intrusion switch slot
4. intrusion switch connector on the
system board
55