Back Panel Features - Dell DL1300 Owner's Manual

Back panel features

Figure 3. Back panel features (two PCIe expansion cards)
1. Serial connector
3. iDRAC port (optional)
5. PCIe expansion card slot (x8 slot, low profile)
7. Power supply unit (PSU)
9. System identification connector
Table 6. Back panel features (two PCIe expansion cards)
Item Indicator, button, or
connector
1 Serial connector
2 System identification
button
3 iDRAC port (optional)
4 USB connectors (2)
5 PCIe expansion card slot
(x8 slot, low profile)
12
2. System identification button
4. USB connectors (2)
6. PCIe expansion card slot (x16 slot, full height)
8. Ethernet connectors
10. Video connector
Icon Description
Enables you to connect a serial device to the
system.
Enables you to locate a particular system within a
rack. The identification buttons are on the front
and back panels. When one of these buttons is
pressed, the LCD panel on the front and the
system status indicator on the back flash until one
of the buttons is pressed again.
Press the button to turn the system ID on or off. If
the system stops responding during POST, press
and hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset the iDRAC (if not disabled in F2 iDRAC
setup) press and hold the button for more than 15
seconds.
Enables you to install a dedicated management
port card.
Enable you to connect USB devices to the system.
The port is USB 3.0-compliant.
Enables you to connect a PCI Express expansion
card.